A spot reading tells you the insulation resistance at one voltage. A PI test tells you how resistance changes over time. But neither one tells you how the insulation responds to increasing electrical stress. That’s what the step voltage test does. It applies voltage in defined steps — 500V, then 1000V, then 2500V, then 5000V — and measures… Read More »
You don’t always have 10 minutes for a full polarization index test. Sometimes you need a quick answer: is this insulation healthy or not? That’s where the dielectric absorption ratio comes in. The DAR gives you a meaningful diagnostic in just 60 seconds. It’s not as thorough as the PI, but it’s far more useful than a simple… Read More »
The polarization index test is the most reliable way to assess insulation condition on motors, generators, and other rotating machinery. It goes deeper than a standard 60-second megger reading and gives you a result that’s independent of temperature and equipment size. If you only have time for one insulation test on a critical motor, make it the PI… Read More »
Every wire, motor, transformer, and cable in your facility is wrapped in insulation. That insulation is the only thing standing between normal operation and a ground fault, a fire, or a serious injury. Insulation resistance testing tells you if that barrier is still doing its job. It’s simple, non-destructive, and takes minutes. Yet it’s one of the most… Read More »